北京永能科技井下人员定位系统

KJ212井下人员管理及紧急搜救系统工程设计安装手册版本号：V3.0.版权所有KJ212井下人员管理及紧急搜救系统-V3.0第2页共25页工程支持热线：[e-mail]目录一、系统简介..........................................................................................................................................4概述················································································································4系统图·············································································································5连接示意··········································································································5系统构成主要设备······························································································6二、系统设计..........................................................................................................................................8准备阶段··········································································································8步骤..................................................................................................................................................8注意事项..........................................................................................................................................8设计阶段··········································································································8步骤..................................................................................................................................................8注意事项..........................................................................................................................................9三、安装................................................................................................................................................10安装准备·········································································································10安装步骤·········································································································11注意事项·········································································································12四、系统调试........................................................................................................................................13检查网络IP·····································································································13调试采集器工作状态··························································································13标识卡的测试···································································································14五、主要构成产品介绍........................................................................................................................17KJJ108光纤数据传输接口···················································································17EDS-405井上设备通讯箱····················································································18KDW-29本质安全型电源····················································································19KGE102-RX无线数据采集器···············································································20KGE102-TX标识卡···························································································23KJ212井下人员管理及紧急搜救系统-V3.0第3页共25页工程支持热线：[e-mail]212井下人员管理及紧急搜救系统是一个具有极大的灵活和扩展性的井下人员监测系统，其不但可用于人员的监测，也可使用于车辆、设备等移动目标的位置监测。根据不同的矿山情况及具体要求，调整不同的产品可满足不同的需求。本手册用于指导KJ212井下人员管理及紧急搜救系统的设计，在矿井设计时应尽量按本手册要求进行，如有其他问题敬请参阅《KJ212井下人员管理及紧急搜救系统技术白皮书》，或致电本公司工程维护热线010-51292806，我们将竭诚为您服务。KJ212井下人员管理及紧急搜救系统-V3.0第4页共25页工程支持热线：[e-mail]一、系统简介概述KJ212井下人员管理及紧急搜救系统是由地面监控中心主计算机在系统软件支持下，通过KJJ108光纤数据传输接口（或直接接入EDS405光电转换接口）和沿巷道铺设的通讯光/电缆，定时对井下固定安装的KGE102-RX无线数据采集器进行数据巡检和信息采集，KGE102-RX无线数据采集器将自动采集有效识别距离内的KGE102-TX标识卡的信息，并根据软件系统指令，通过传输网络将KGE102-TX标识卡的信息、采集时间等相关数据传送至地面中心站。以井下固定安装的KGE102-RX无线数据采集器为定位点，经分析处理后，即可将井下人员（也可用于井下机车等移动目标）的动态分布在主计算机系统软件界面中得以实时反映，从而实现井下人员状态在井上可视化管理的目的。KJ212井下人员管理及紧急搜救系统-V3.0第5页共25页工程支持热线：[e-mail]系统图本系统分为地面和井下两部分，地面设备可包括：中心控制计算机、EDS405光电转换接口及软件系统、控制大屏幕、连接线组成，井下设备由KJJ108光纤数据传输接口、KGE102-RX无线数据采集器、KDW29基地电源、连接光/电缆及KGE102-TX标识卡等组成，如图：连接示意A.KJJ108光纤数据传输接口相互间用光纤相连；与井下的KGE102-RX无线数据采集器以RS485总线方式连接；B.KGE102-RX无线数据采集器通过RS485通讯总线与KJJ108光纤数据传输接口相连；C.KGE102-RX无线数据采集器的电源由本质安全型KDW29基地电源提供，每个KDW29基地电源可供直径1公里范围内的3-4个KGE102-RX无线数据采集器正常工作。KJ212井下人员管理及紧急搜救系统-V3.0第6页共25页工程支持热线：[e-mail]212系统连线示意图系统构成主要设备地面部分编号名称型号配置备注1中心控制计算机P43.0G/512M/80G以上WINDOWS2000以上建议使用WINDOWSXP系统2LED显示屏建议使用同步传输系统3井上通讯箱EDS405EDS405-A/BEDS405-A光接口EDS405-B电接口4应用软件KJJ2125UPS电源额定容量（KVA）:1\输出电压（V）:220-240APC、山特6本质安全型电源KDW29当使用EDS405-B时必须使用（亦可采取自井下反供的方KJ212井下人员管理及紧急搜救系统-V3.0第7页共25页工程支持热线：[e-mail]式供电）传输部分编号名称型号配置备注1光纤传输接口KJJ108A/B2个光纤接口，4个RS485接口，3个RJ45接口。KJJ108A单模KJJ108B多模2光缆单模/多模建议使用16芯以上3电缆MHYVRP1×4×7/0.43如单独供电也可采用MHYVRP1×2×7/0.43无线数据采集部分编号名称型号配置备注1无线数据采集器KGE102-RX2.4G无线接收2本质安全型电源KDW29输入127v，输出12v传输部分的每