南昌大学金工实习数控车床成品编程

数控车成品：塔。就是下面图里这个了，特别精致小巧，很漂亮。注：T表示换刀，根据自己的机器的刀号改一下T后面的数字编程（我分了三部分：粗车线条，粗车轮廓，最后精车成形）%O2014T0808M03S400G00X25Z2F0.1G00X17G01Z-43X25G00Z2G00X14G01Z-41X17G00Z2G00X10G01Z-27X14G00Z2G00X6G01Z-10X10G00Z2G00X3G01Z-3X6G00Z2G00X3G01X5Z-10X9.5Z-11Z-12X6Z-13Z-15X9.5Z-18Z-21X9Z-21.5X8Z-23Z-26X13Z-28Z-29X13.5Z-31X11Z-36X12Z-38X12Z-40X17Z-43X22Z-48X22Z-51X19Z-55Z-64G01X22G00Z-55G01X20X18X15Z-58Z-62X17Z-63X19Z-63.5X20G00Z-57G01X17X14Z-58Z-62X22G00Z2G00X25Z2G00X1Z2G01X1Z0X3.61Z-4.9X2.3Z-5.72X2.63Z-9.8X9.17Z-11.43X3.24Z-13.07Z-15.52G03X7.23Z-22.05R4.08F0.05G02X13.25Z-29.07R4.9G01X7.53Z-37.57Z-40.02G03X9.17Z-58.16R9.8F0.05G02X18.97Z-63.88R8.17G01X25G00X24Z2G00X0Z2S600G01X0Z0F0.05X2.61Z-4.9X1.3Z-5.72X1.63Z-9.8X8.17Z-11.43X2.24Z-13.07Z-15.52G03X6.23Z-22.05R4.08F0.05G02X12.25Z-29.07R4.9G01X6.53Z-37.57Z-40.02G03X8.17Z-58.16R9.8F0.05G02X17.97Z-63.88R8.17G01X24G00X100Z100T0606F0.025S300G00X33Z-69.88G01X-1G00X100Z100M05M02%